How To Use A Joint Roller

Close the roller and roll back and forth to ensure even distribution.

How to use a joint roller. Load paper into the roller with the sticky side up. Make sure to do this slowly and at a constant speed to ensure the joint is rolled evenly. Roll until just the adhesive strip sticks out.

Spread some weed throughout the roller the same way you usually would on a rolling paper. There should be just a tiny bit sticking above the fold the area between the two rollers but not much. Take a rolling paper that matches the length of your joint roller and place it between the two rolling pins with the sticky gum side of the paper facing you.

I hope you enjoyPuff Chew. The first thing you need to learn to roll a perfect joint using a joint roller is the proper way to load the filter. You should be able to see grooves on each side for the pegs to go through use those.

Fill it up with the weed either tightly or heavily. How to use a joint roller Loading Open up the rolling machine by sliding one of the rollers up. A simple one minute video showing you how to use the RAW Joint Roller Machine.

Step 1 and 2. When ready close the roller. Start by opening your joint roller and placing your filter tip at the end.

Pick it up and turn both rollers toward you using your fingers to keep the plastic taut around the inside so that the guts get nice and tight. Then take your weed and place it between the two rollers on one side. PAPER Insert a sheet of rolling paper between the rollers gummed side toward you.